This is all very nice but does not help installing. – Then I copied the W98 install disk on this stick, and booted.įor a fraction of a second, I see the W98 install screen with the windows logo on it, and then the system falls back to a C:\ command prompt. Stick also boots nicely, and gives me a fancy C:\ sign when ready. – Formatted my stick with HP tool in FAT32 file system, with system files from Windows 98. Also does not find any drives when both drives are installed at the same time. Tried this with two different drives, one SATA and one IDE drive, same result. “No drives found, aborting installation”. It tries to create the device with the name OEMCD001 but fails to do so. The Driver used on this CD is from Oak Technoloy, called OTI-91X ATAPI CD-ROM device driver, Rev D91XV352. The Windows98 Setup files were not found. At the end of the day however, there is a message saying: Then, after selection of Start from CD Rom, a number of drivers seem to be started. Then there is a nice Microsoft Windows 98 startup menu which asks me whether I want to start from CD ROM, or whether I want to start the computer with or without CD support. – the CD is bootable, boots nicely from the CD and asks me if I want to boot from hard disk or CD. Trouble is, the PC is quite a lot newer than W98. I’m trying to install Windows 98 SE on an industry standard PC.
0 Comments
Leave a Reply. |